this is what a helpful answer should look like :)

At first I tried it with the HVIL-Jumper. It did not working. Then I checked the Parameters again and found out, that the OCURLIM was still negative from testing. I changed it and now it is working again with the jumper.

On Pin 4 and 9 I messured ...

Thank you for your quick response,

I measured directly and found the following values:
IC5
Pin1: 4.96V
Pin2: 4.96V
Pin3: 3.75V before I press the startbutton and after trying to start: 0V
Pin4: 4.96V
Pin5: 4.96V
Pin6: 0V before and after the start attempt

IC4
Pin4: 1.45V
Pin5: 1.69V
Pin6: 1.45V ...

Hello together,

At first I have to say sorry for my english, it is not the best... place ask, when I write strange things :)

What happend so far:
I bought a V6 Logic Board from Johannes and build it into a SDU.
I wired everything for a Benchtest with 2 Model S Batterymoduls (47Vdc).
I had a little ...

@alehandro: fantastic VW Bus! I would like to know, how much kwh does it take on 100km?
Thanks for the vid
Ben

Hey Johannes,
what a great project! I have nearly the same goal! Here you can see my project!
https://openinverter.org/forum/viewtopic.php?f=11&t=1597

Did you found some more informations for the right angle of the SDU?
My Plan is to have the rear screw 15mm higher than the front screw of the SDU ...

here some picture of the car...

Hi!
I think it's time to say "hello".
I have read a lot on this website for a couple of weeks and i think it is time to introduce myself and my project.

My Name is Ben and I'm living in Münster (Germany). I like old cars and electronics, so it was only a matter of time when I start my EV ...