As seems to be the way on this forum those willing to help are the least able and those able to help the least willing. No matter. I'm installing a 450h into my E39 presently and the problem or problems will be found, rectified and published by me.


I do have a setup on hand that is not working ...

Would it be possible to share the .bin file for the modified code to run MG2? Also doing some zombie troubleshooting

Yes, file is attached (b9c8f19 with MG1 disabled)


Thank you for testing. In terms of the release code not working can you give any more details?

Unfortunately, I cannot give ...

Ok so I have tried everything I said I would. Here are the results:

Ground the shield wires for the communication between the Zombieverter and the inverter (cable was shielded but shield was not grounded properly)
No change, still jerky

Ground the shield wires for the communication between the ...

But if your setup may be creating nonexistent problems, why are you chasing them?


The original idea was to quickly test to see if the setup considered would work. But your question is full of wisedom, I will reconsider spending time on a temporary setup chasing potential "non problems".

Thanks for all the feedback. Just to reiterate, this is a preliminary setup, not a definitive one. I am obviously planning on using a 350V nominal battery and using rubber mounts. The idea of this setup is to iron out any problems beforehand and make sure I have a proper architecture.

I have tried ...

Hello,

I am having a problem where my GS450h transmission is causing a jerking motion, shaking on the vehicle. Video:
https://photos.app.goo.gl/7tgTdY3crAGy2M1d7

I have installed the transmission on my Scion FRS with a preliminary battery (~100V) and taken it for a quick spin. I am using the ...

Hello everyone,

I would like to work on the gearing of the transmission (changing between LOW and HIGH gear). In all code I can read (VCU and Zombieverter), the gear outputs (SL1, SL2 and SP) are set to '0':
DigIo::SP_out.Clear();
DigIo::SL1_out.Clear();
DigIo::SL2_out.Clear();
I have tried ...

dukbilt wrote: ↑Mon Apr 18, 2022 9:21 am So - is it confirmed that the G9200-33171 (Camry) inverter DOES work with the Openinverter brain board?

I was basing the inclusion of this inverter because of this post -> viewtopic.php?p=28941&hilit=33171#p28941. It seems to work with damien's VCU.

Hello,

I am about to buy a GS450h transmission and inverter. I am trying to find the latest information on the compatibility with the boards that Damien created (including latest ZombieVerter/V3 VCU).

So far I got this but i'd like some sort of confirmation before I buy.

Compatible inverters ...

Hello all,

I am very sorry if I'm not asking at the right place, I am new to the forum. I have looked around for quite some time and can't seem to find the information I need. I am converting a Scion FRS/Subaru BRZ to an EV. I am very interested in the GS450H transmission because it leaves the ...