Perfect, I will pull a CAN log shortly and post it.

Apologies in advance for the spam.

Edit: I hooked up a Arduino nano with the Rst and Gnd jumped intern making it a serial adapter using the FTDI chip. I hooked It up to Conn9
Gnd to Gnd
Rx to RX
Tx to TX
5v to 5v

And the board did not power ...

Yes, the Can jumper is soldered and I have verified it is a good solder joint.

A bit more information.

The board is not outputting any of the required voltages on connector A. No "OUT2 - AC present" on pin A1, in other words. A6 has nothing either.

Thanks, in advance, for any suggestions you can offer.


I am also experiencing the same situation. The control board is ...