No this is a separate issue from can bus connectivity.

When the can bus is working and the Webui is working the above problem exists.

i.e.
Changing parameters has an immediate effect on the board. However after saving the changed parameters to flash and power cycling the webui shows the old ...

We are using the Model S Small front motor controller board by Damian McGuire. When we change parameters and save to flash the Web UI says they save to flash was successful. When we power cycle the board the "saved" parameters are reverted back to their old values.

We are using the Model S front motor control board by Damian McGuire and the included ESP32 CAN Wifi board.

We notice intermittently when both boards are powered up the Web interface complains that the CAN connection is not working.

Is there a sequence these two boards need to be powered up in ...