Excellent work,

What coupler did you use on leaf spline shaft ?

Going to have a measure up later I think

Thanks will take a look, Just had a quote of $1400 for a plate and coupler :twisted: That would blow the budget on the 1000 euro build Think I will take a chance and go ahead and get some aluminium plate. .....right where is my jigsaw, was watching on YouTube how some guys are cutting 12mm plate wit...

Thats good nearly getting the confidence to start making it myself>

Will you youtube your adapter build, how will you couple it and get the shafts perfectly aligned.

Might need two plates for the EM57 motor as has a overhang on the motor.

That looks really good

I have been emailing lots people about getting a leaf adaptor plate made only to be meet with silence.

Is that 25mm plate ? did you cut down the shafts on the motor or gearbox, On the EM57 the motor shaft looks like it sticks out over 50mm.

How you project going Johu,

Did you manage to connect up the Leaf motor, what coupler did you use in the end ?

nice work.

look forward to your results

OK, thanks

60mph isnt a really a good top speed then then , what is the maximum RPM thats J huebner controller will go up to ?

....so I found a online speed calculator

RPM-6000
Tire size 14"
Gear Ratio 8:1 ( leaf gear box ?)

Potential Calculated Vehicle Speed: MPH 79.24 or KM/H 127.52

These figures don't seem unreasonable if accurate

yes and those who use the complete drive unit with only one gear. Here here! I intend to use Leaf motor with original diff and 360Vdc system. I must get to 10Krpm at least to have 140km/h speed. I am thinking with your idea of leaf motor/gearbox fitment. What would a 360v pack with motor rpm pf 600...

will they move ? doesn't either half clamp down on the splined output shafts, looks a good part

this looks really interesting -how many cells will each board take ?

johu wrote: ↑Sun Feb 10, 2019 6:12 pm

I have started testing the new BMS slave boards and actually mounted it to the battery today.

Any plans to release your BMS boards ?

many thanks will take a look,

is it feasible to build this board ( I wish I had the money to buy a pre build one to support the work) I have limited EE skills

Is there a BOM for the rev 3 board ?

Hello, I want to build this I'm NOT a EE :? but have some basic knowledge with the components, Is it possible to explain how this actually connects to the resolver wiring from the motor (Ex, Sin, Cos ) would be possible to see a reverse side of circuit pref borad in the pic could someone design a PC...