No it uses seperate lines for A and B there is no linking. Most likely you need to swap A and B.


I double checked my wiring for encoder channels A and B and everything was correct. As I was troubleshooting, I noticed that when I plotted the angle parameter and rotated the motor shaft by hand ...

I am working to get an industrial ACIM running using a throttle pedal. I am able to successfully spin run my motor in manual mode, so now I'm on to getting my setup to work using an E46 hall effect throttle pedal. After spending time fiddling about with my inverter and searching this forum, I was ...

Hi All,

I’m trying sort out a battery pack for doing initial shakedown testing for a conversion. I’ve got a gen3 Prius inverter with an EVBMW logic board. Basically, I’m looking for something between 300-380V that would be able to provide a good amount of current to do some shakedown runs for ...

I wanted to share my experience with doing a Gen3 Prius logic board swap with the group. I made a YouTube video walking through some aspects of doing the logic board swap (see below).

I’m doing my swap with a G9200-47210 inverter that I bought on eBay. From a little bit of internet sleuthing, it ...