openinverter forum

I am almost at the point of fitting all of my components to a vehicle and have started to consider how to create the wiring loom in the most tidy and efficient way. How do people normally go about this? Obviously i could just buy lots of reels of different wire and create my own but i was wondering if there is a generic loom package (or similar) available anywhere? Im thinking it would basically be like a tow bar wiring loom (with more wires) that i could branch out of and chop to suit?

I usually get these wire bundles. They have another bundle as well with different colors/stripes.

https://www.diyautotune.com/product/meg ... 0-39-long/

Will also use multiconductor tray cable if I need to run a bunch of signals front to rear. Ill terminate both ends with a Deutsch HDP20 connector and populate that as needed.

Example https://www.ebay.com/itm/254509068805?h ... Swxj9eQdVb
https://www.ebay.com/itm/331895871078?e ... SwYvFZNhJS

Awesome - just what I was looking for thank you!