Mapping can messages
Posted: Wed May 31, 2023 4:46 pm
Using 5.24r
I've battled for a few hours to get the values i want sent in can messages. I want to receive id & iq, and i did have il1 & il2 mapped but not sure these are as useful so tried to swap them out.
I've tried to delete the il1 & il2 mappings and use the same can id etc for id & iq. I can unmap il1 & il2 and save the params and even map id & iq, but il1 & il2 keep returning when i issue a 'can print' command. I've tried different combinations of saving parameters and restarts but i can't get what i want to stick.
I've tried can clear, and entering all from scratch but get the same. It is as if these variables are somehow overlayed in the code, maybe a cut & paste issue or have i misunderstood something ?
I've battled for a few hours to get the values i want sent in can messages. I want to receive id & iq, and i did have il1 & il2 mapped but not sure these are as useful so tried to swap them out.
I've tried to delete the il1 & il2 mappings and use the same can id etc for id & iq. I can unmap il1 & il2 and save the params and even map id & iq, but il1 & il2 keep returning when i issue a 'can print' command. I've tried different combinations of saving parameters and restarts but i can't get what i want to stick.
I've tried can clear, and entering all from scratch but get the same. It is as if these variables are somehow overlayed in the code, maybe a cut & paste issue or have i misunderstood something ?