outlander rear motor + openinverter board ?
Posted: Thu Oct 26, 2023 10:36 pm
I would like to know if this is possible with FOC firmware.
Initially there is something that I don't see how to solve, because in the motor resolver connector there are 6 cables (R1, R2, S1, S2, S3, S4) and on O.I. mainboard v3, I only see 4 entries in JP2:
pin1=S3
pin2=S1/S4 (two wires from motor?)
pin3=S2
pin4=R1
Where would R2 go?
Besides this, does anyone see any other problems?
Initially there is something that I don't see how to solve, because in the motor resolver connector there are 6 cables (R1, R2, S1, S2, S3, S4) and on O.I. mainboard v3, I only see 4 entries in JP2:
pin1=S3
pin2=S1/S4 (two wires from motor?)
pin3=S2
pin4=R1
Where would R2 go?
Besides this, does anyone see any other problems?