Page 1 of 1
Wanted: Tesla Model 3 PCS Coolant Connector
Posted: Fri Jul 26, 2024 7:25 pm
by nkiernan
Know it's a long shot, but worth asking. Any chance anyone might have a spare 90 degree coolant connector to suit the TM3 PCS. Have a straight through (shown in last photo below) I don't need that I could swap if this suited anyone better than their 90 deg!!?
Re: Wanted: Tesla Model 3 PCS Coolant Connector [SOLD]
Posted: Wed Jan 29, 2025 8:14 am
by EV_Builder
What's the pressure? Can't you 3D print it?
Re: Wanted: Tesla Model 3 PCS Coolant Connector
Posted: Thu Jan 30, 2025 2:14 pm
by nkiernan
Looked at 3D printing and others on the forum have modelled versions of these I think, but wasn't happy to go that route as its inside an enclosed HVJB. Worked a solution using the parts I had in the end