openinverter forum

Ok, my Zombieverter board has arrived.
The only soldering needed appears to be the pin-headers for the wifi board.
3 different sets were supplied.
1) standard pin header
2) socket header
3) Extended pin socket header.

I haven't found any docs on which set to use, so I'm making a guess...
Solder #2 to the Zombieverter, and #1 to the bottom of the Wifi board?
OR
#2 to the Zombieverter, and #3 to the top of the wifi board - so something could be stacked on it? (umm, like what?)

Damien does option 1. The other option is pin header on the board and standard header on the wifi module.

Ok thanks. That doesn't appear to be one of the videos that is on the wiki page.

I admit, that even if I had seen a link to it - I wouldn't have watched it.
Spending over an hour watching a video that shows something that could be written on a couple of pages with a few photos is one of my annoyances with the "create long videos to document simple tasks" concept.