zombieverter universal wiring interface + 3d printed case

[Bratitude]

i use the zombie for all sorts of projects, and generally recommend it to customers. the zombie wiring is 95% the same across the board...so why am i making custom wiring harnesses for every project?..... and some customers are overwelled(ironically by wiring in a EV conversion).

why not just make a "universal" harness?

what i need is a box with everything:
zombie, dedicated connectors, pre-fused, powered, and mounted.

but needs to be flexible enough for adding more connectors or devices to the zombie...without having to rewire everything...

which has resulted in this:

features:
-OBD-ii port
-little fuse PDM
-deutsch DT connectors
-dedicated power deutsch DTP connector

each connector will be pre wired with the necessary can, power, signals, etc so just plug in throttle, inverter, start/run/direction, contactors, etc and you have a up and running ev system.

also found the alibaba case kinda sucks, as half the time you dont get a seal and they dont have great mounting tabs.

so designed a 3d printable case:

[Jacobsmess]

This is great, look forward to seeing some end results

[Bratitude]

damien sent over the original case drawing

Jo56-1.pdf

(41.9 KiB) Downloaded 320 times

[Bratitude]

heres files for a 3D printable zombie case and the header.

it works for now, still lots to clean up, but if you need a case here ya go!

ZOM_CASE_2.zip

(6.88 MiB) Downloaded 312 times