The HV interlock (might also be a PP passthrough) on the AC connector is connected to the LV connector (pin 11). it's not important. I will fix the wiki.
You have the HV interlock on the DC connector shorted?

your test file look good.
AC max current = 32A
DC max current = 2A
DC max voltage ...

Just wondering if it's worth playing some other files but the 29C?

https://github.com/damienmaguire/MG-EV- ... c_can3.csv

I was hoping some CAN spoofing can help with that, although I am under impression from Damien's description this is very easy going charger that doesn't ask for too much to make it work

Got it, thank you. I will make that PP/HVIL redundant. My original wake up wire seems to be not needed too.
Yes, I have a jumper on DC connector. I am just trying desperately to see the load on my DC circuit made of two bulbs and a capacitor from my dead DMOC before bolt the chrger to the car.

I ...

Did you look at the info on the wiki https://openinverter.org/wiki/MG_ZS_Charger

I don't know what your setup is like. But the charger needs a CP signal and the 0x29C can message to work. And the other connections in the wiki.

Here is a DBC file to see the values sent by the charger. Just ...

MG tend to iterate component quite rapidly it seems. What is the part number for the charger you have?


That issue is now sorted. The seller was under impression all Molex connectors are keyed and supplied the opne that fits from a different harness :roll:
The part number is ZS10BC6600A, the ...

Yes I had to connect PP to the charge socket to get it to work.


Makes me wonder if Gen1 also requires a PP wire. A bit of grey area. According to the video it either needs a clean CP which I have or some CAN messages for DC to kick off.
Can't start mine on the bench for some reason. Not before ...

Alright Gents,
Help is needed and will be much appreciated.
I was hoping to replace a Brusa charger on my AZD frankenstein and to wire it up as per Damien's video, but the Molex pinout on the old connector appears to be completely different with some pins just blanked off as shown in the attached ...