Hi Tom,
Thanks for the reply.
I got it working, till a certain point.
Now, when i change the code to read the canbus messages coming from the BGTW (that reads the CMCs from the Taycan Modules), the watchdog resets simpbms constantly. I have no clue why?

Hello, i'm trying to adapt the simpbms software to use another cell management board (for Taycan modules; it sends all needed info via canbus).

Started from the Outlander fork (https://github.com/Tom-evnut/OutlanderPHEVBMS/tree/master/OutlanderBMSV2) and figuered that i just replace the outlander ...

Thanks. Another set of questions:

1. i discovered the simpcharge hardware to provide J1772 functioning - did i understand this right?
2. where can i buy both the simpbms and simpcharge hardware?
3. what firmware to use?
4. i have a hardware board that can do the J1772 protocol handshake. But it has ...

Hi,

a question: what is the best fork of simpbms to start from to build a bms that gets all its input data

* cell voltages, cell temperature via canbus
* pack voltages and amps via cabus (IVT-S)
* Elcon chargers and DC/DC controller (canbus)

Thanks for helping!

Best regards,
Bart

Hi EV_Builder,

Questions: did you get the CSC boards of the Taycan Battery Modules to work with a BMS? What BMS?

I'm upgrading a car that we converted 3 years ago and i have the same battery modules. Also have the BJB and BMC from that Taycan Battery pack and need to figure out what to do so that ...