How wide can I expect for the syncofs values when manualid set to 100? I get some 1000 points or more where it stand still and I'm thinking, this can't be right. From Damiens video I get that at 10100 it move and at 10120 it stands still but no mention of when it starts to move again? But I still think it should be like 50 points or so?
What is your result?
How wide is your syncofs standstill?
-
ZooKeeper
- Posts: 526
- Joined: Mon Mar 30, 2020 10:23 pm
- Location: USA
- Has thanked: 8 times
- Been thanked: 5 times
Re: How wide is your syncofs standstill?
I get no rotation between 10,800 & 11,200 @ 165v and MID <= 75.
Time for ICE Melt
Huebner VCU controlling a Gen2 Prius Inverter attempting to power a Leaf EM57 motor.
"Talent is equally distributed but opportunity is not." - Leila Janah
Huebner VCU controlling a Gen2 Prius Inverter attempting to power a Leaf EM57 motor.
"Talent is equally distributed but opportunity is not." - Leila Janah
-
johu
- Site Admin
- Posts: 7182
- Joined: Thu Nov 08, 2018 10:52 pm
- Location: Kassel/Germany
- Has thanked: 552 times
- Been thanked: 1918 times
- Contact:
Re: How wide is your syncofs standstill?
Might also be good to know that the jitter on a well shielded resolver is still about +-180 digits (+- 1°), so it makes limited sense to tune much below that figure.
Support R/D and forum on Patreon: https://patreon.com/openinverter - Subscribe on odysee: https://odysee.com/@openinverter:9