A couple of people have asked about a 3d printed housing or a housing in general for the SimpBMS.
I have drawn one up, it comes in two pieces a bottom and a cover. It is deigned to work with drg-01 din mounts if so desired.
The top half just fits snug on the bottom so no true "fixings" are used. The SimpBMS is held into the base with 4 No.2 selftapping screws.
SimpBMS V2.3/2.4 Printed Housing
- tom91
- Posts: 2467
- Joined: Fri Mar 01, 2019 9:15 pm
- Location: Bristol
- Has thanked: 217 times
- Been thanked: 609 times
SimpBMS V2.3/2.4 Printed Housing
You do not have the required permissions to view the files attached to this post.
-
- Posts: 277
- Joined: Sun Jan 03, 2021 6:12 am
- Has thanked: 71 times
- Been thanked: 29 times