Hi Everyone,
I'm in the beginning stages of my EV project and I finished soldering the connections to the main board as well as the pin connectors for the brain board. Forgive me if I'm overlooking the obvious but I cannot seem to find anywhere in the documentation or the forum where to solder the resistor that comes with the kit. If anyone could provide some guidance, I'd appreciate it. Thanks.
Nissan Leaf Gen2 Controller - Community Edition
-
fortshafter17
- Posts: 1
- Joined: Sat Feb 22, 2025 1:02 am
-
johu
- Site Admin
- Posts: 6618
- Joined: Thu Nov 08, 2018 10:52 pm
- Location: Kassel/Germany
- Has thanked: 341 times
- Been thanked: 1484 times
- Contact:
Re: Nissan Leaf Gen2 Controller - Community Edition
The resistor with the Leaf kit is for optional CAN termination and it fits only in one spot. In doubt omit it.
Support R/D and forum on Patreon: https://patreon.com/openinverter - Subscribe on odysee: https://odysee.com/@openinverter:9