openinverter forum

Hello. I have a task to create an electric buggy. I want to use the native battery and inverter from the nissan leaf 1 gen. I need a slow charging function from the native connector and about 50 kW of power on the engine. Which of the boards can use these functions? Please do not be angry, I am new to this forum and I use a translator to communicate with you. Thank you

Zombieverter board will work for that just fine. Plenty of documentation on here and the wiki as well for running a leaf setup.

LRBen wrote: ↑Thu Jun 12, 2025 6:49 pm Zombieverter board will work for that just fine. Plenty of documentation on here and the wiki as well for running a leaf setup.

get more details about Zombieverter here viewtopic.php?t=4934

There is no controller available that will run the gen 1 Lea on board charger.

The zombiverter will run the gen1 leaf motor+inverter
And dose CHAdeMO

but dose not run the gen1 leaf charger

Bratitude wrote: ↑Tue Jun 17, 2025 4:25 am The zombiverter will run the gen1 leaf motor+inverter
but dose not run the gen1 leaf charge

Where you getting this info from? I do not believe this to be the case.

tom91 wrote: ↑Tue Jun 17, 2025 6:41 am Where you getting this info from? I do not believe this to be the case.

I vaguely remember one of Damiens videos on the stack mentioning something along the lines of this. May well be legacy information.

Here is info on what it is controlling and what not https://openinverter.org/wiki/ZombieVer ... gers/DCDCs:

And there it says:
Chargers/DCDCs:
Nissan Leaf PDM (Charger and DCDC) Gen1,2 & 3

I have not tested myself yet but I am going to, maybe even this year!