[WIP] Voltswagen T2 -76
-
johu
- Site Admin
- Posts: 6618
- Joined: Thu Nov 08, 2018 10:52 pm
- Location: Kassel/Germany
- Has thanked: 342 times
- Been thanked: 1484 times
- Contact:
Re: [WIP] Voltswagen T2 -76
That or maybe bus bar your way out. Towards the middle of the motor, then cables?
Support R/D and forum on Patreon: https://patreon.com/openinverter - Subscribe on odysee: https://odysee.com/@openinverter:9
-
Cera
- Posts: 82
- Joined: Thu Feb 10, 2022 10:08 am
- Location: Finland
- Has thanked: 30 times
- Been thanked: 53 times
Re: [WIP] Voltswagen T2 -76
Yeah I'm currently thinking of a set of 90deg busbars towards the middle of the motor, enclosed safely in some 3D printed case, then 50mm2 cables to inverter. 
not too worried, I'm sure this can be made to fit somehow.
not too worried, I'm sure this can be made to fit somehow.